自在自线亚洲а∨天堂在线-中文字幕一区视频播放-扒开双腿猛进入喷水高潮叫声-欧美日本亚洲一区二区-老熟妇高潮偷拍一区二区-国产精品高清一区二区不卡-午夜色福利视频一区二区三区-亚洲国产成人精品福利在线观看-亚洲欧美成人一区二区在线电影

Atmel 公司的ATA8201和ATA8201是UHF  ASK/FSK 接收器，它的功耗很低，ATA8202的工作頻率從433 MHz 到 435 MHz，而ATA8201 的工作頻率從 313 MHz 到 317 MHz。器件集成了具有方案低相位噪音的 VCO, PLL以及回路濾波器，ASK/FSK的接收靈敏度高達–105 dBm，廣泛用在消費電子和工業市場的遙控系統，接入控制系統，家庭自動化和娛樂，玩具以及論胎監視系統等。本文介紹了ATA8201和ATA8201的主要特性，方框圖，應用系統方框圖以及3V和3V的應用電路圖。

UHF ASK/FSK Receiver ATA8201/ ATA8202

The ATA8201/ATA8202 is a UHF ASK/FSK transparent receiver IC with low power consumption
supplied in a small QFN24 package (body 5 mm 5 mm, pitch 0.65 mm). ATA8202 is used in
the 433 MHz to 435 MHz band of operation, and ATA8201 in 313 MHz to 317 MHz.

For improved image rejection and selectivity, the IF frequency is fixed to 440 kHz. The IF block
uses an 8th-order band pass yielding a receive bandwidth of 420 kHz. This enables the use of
the receiver in both SAW- and PLL-based transmitter systems utilizing various types of data-bit
encoding such as pulse width modulation, Manchester modulation, variable pulse modulation,
pulse bbbbbbbb modulation, and NRZ. Prevailing encryption protocols such as Keeloq® are easily
supported due to the receiver’s ability to hold the current data slicer threshold for up to 52 ms
when incoming RF telegrams contain a blanking interval. This feature eliminates erroneous
noise from appearing on the demodulated data output pin, and simplifies software decoding
algorithms. The decoding of the data stream must be carried out by a connected microcontroller
device. Because of the highly integrated design, the only required RF components are for the
purpose of receiver antenna matching.
ATA8201 and ATA8202 support Manchester bit rates of 1 Kbit/s to 10 Kbits/s in ASK and 1 Kbit/s
to 20 Kbits/s in FSK mode. The four discrete bit rate passbands are selectable and cover
1.0 Kbit/s to 2.5 Kbits/s, 2.0 Kbits/s to 5.0 Kbits/s, 4.0 Kbits/s to 10.0 Kbits/s, and 8.0 Kbits/s to
10.0 Kbits/s or 20.0 Kbits/s (for ASK or FSK, respectively). The receiver contains an RSSI output
to provide an indication of received signal strength and a SENSE bbbbb to allow the customer to
select a threshold below which the DATA signal is gated off. ASK/FSK and bit rate ranges are
selected by the connected microcontroller device via pins ASK_NFSK, BR0, and BR1.

主要特性：

Transparent RF Receiver ICs for 315 MHz (ATA8201) and 433.92 MHz (ATA8202) With High Receiving Sensitivity
Fully Integrated PLL With Low Phase Noise VCO, PLL, and Loop Filter
High FSK/ASK Sensitivity:–105 dBm (ATA8201, FSK, 9.6 Kbits/s, Manchester, BER 10-3)
114 dBm (ATA8201, ASK, 2.4 Kbits/s, Manchester, BER 10-3)
104 dBm (ATA8202, FSK, 9.6 Kbits/s, Manchester, BER 10-3)
113 dBm (ATA8202, ASK, 2.4 Kbits/s, Manchester, BER 10-3)
Supply Current: 6.5 mA in Active Mode (3V, 25°C, ASK Mode)
Data Rate: 1 Kbit/s to 10 Kbits/s Manchester ASK, 1 Kbit/s to 20 Kbits/s Manchester FSK With Four Programmable Bit Rate Ranges
Switching Between Modulation Types ASK/FSK and Different Data Rates Possible in
≤1 ms Typically, Without Hardware Modification on Board to Allow Different Modulation Schemes

Low Standby Current: 50 μA at 3V, 25°C
ASK/FSK Receiver Uses a Low-IF Architecture With High Selectivity, Blocking, and Low Intermodulation (Typical 3-dB Blocking 68.0 dBC at ±3 MHz/74.0 dBC at ±20.0 MHz, System I1dBCP = –31 dBm/System IIP3 = –24 dBm)

Telegram Pause Up to 52 ms Supported in ASK Mode
Wide Bandwidth AGC to Handle Large Out-of-band Blockers above the System I1dBCP
440-kHz IF Frequency With 30-dB Image Rejection and 420-kHz IF Bandwidth to Support PLL Transmitters With Standard Crystals or SAW-based Transmitters

RSSI (Received Signal Strength Indicator) With Output Signal Dynamic Range of 65 dB
Low In-band Sensitivity Change of Typically ±2.0 dB Within ±160-kHz Center
Frequency Change in the Complete Temperature and Supply Voltage Range
Sophisticated Threshold Control and Quasi-peak Detector Circuit in the Data Slicer
Fast and Stable XTO Start-up Circuit (> –1.4 kWorst-case Start Impedance)
Clock Generation for Microcontroller
ESD Protection at all Pins (±4 kV HBM, ±200V MM, ±500V FCDM)
Dual Supply Voltage Range: 2.7V to 3.3V or 4.5V to 5.5V
Temperature Range: –40°C to +85°C
Small 5 mm 5 mm QFN24 Package

應用：
Industrial/Aftermarket Keyless Entry and Tire Pressure Monitoring Systems
Alarm, Telemetering and Energy Metering Systems
Remote Control Systems for Consumer and Industrial Markets
Access Control Systems
Home Automation
Home Entertainment
Toys





圖1。ATA8201/2方框圖




圖2。ATA8201/2系統方框圖




圖3。ATA8201/2 3V應用電路圖



圖4。ATA8201/2 5V應用電路圖